Build a full-stack app with TanStack Start

0/28 · 0%

Confirm prerequisites and map the build
12 min
TanStack Start scaffolds with a single CLI command regardless of which package manager runs it afterwards. Record the three basics below before running anything — every later step's commands read them back instead of asking again.
To do
Record the project name
Choose the package manager
npm, pnpm, yarn or Bun — the scaffolding CLI itself is run with `npx`, but this choice decides every install/build/start command shown later.
Check and record the installed Node.js version
Run `node --version` and compare it against the minimum stated on the Getting Started page before continuing.
To note down
Package manager (Required to finish this step)
Which package manager will you use for this project?
Project name (Required to finish this step)
What is the project/app name (used as the directory and package name)?
Installed Node.js version (Required to finish this step)
Run `node --version` and record the output.

0/5 done

Contents